Manual | Caselabs Sma8
Once the internal frame is secure and all internal components are loosely set, the external dress panels can be clipped into place. The doors are retained by heavy-duty hinges at the rear, allowing them to swing open without being fully detached. The lower chamber covers and top cover are then screwed down to complete the structural rigidity.
: Most of the assembly can be completed with a standard Phillips screwdriver, though a nut driver kit (often included) is needed for drive cage installation.
To help tailor this to your specific build project, tell me:
: Used for securing the motherboard, SSDs, and standard drive caddies.
The top cover can accommodate up to a 480 (4 × 120mm) or 420 (3 × 140mm) radiator. You may need to remove the top radiator bracket (secured by thumbscrews), mount the fans and radiator externally, and slide the assembly back into the top chamber. caselabs sma8 manual
Utilize the large rubber grommets bordering the motherboard tray to route the 24-pin, EPS, and PCI-e cables directly into the rear management zone.
If you find a PDF of the original SMA8 manual, please upload it to a public archive like [Archive.org]. With CaseLabs gone, you are now the custodian of history. Do not let the manual disappear.
The case supports dual PSUs. The PSU mounting bracket slides into the lower chamber. Install your power supply before finalizing the lower radiator mounts to ensure clearance.
CaseLabs includes various bags of screws (M3, 6-32, thumbscrews, and frame screws). Sort them into small magnetic trays or cups before starting. Step-by-Step Frame Assembly Once the internal frame is secure and all
Motherboard flips upside down, moving to the left side of the case. Assembly and Installation Lay the motherboard tray flat on your table.
: Utilize the large rubber grommets on the mid-plate and motherboard tray. PSU Installation
The documentation outlines support for massive radiators: up to 560mm radiators in the bottom chamber and up to 480mm/420mm in the top (depending on configuration). Flexible Mounting:
The Ultimate CaseLabs Magnum SMA8 Assembly and Customization Guide : Most of the assembly can be completed
: Requires removing the front bay covers and utilizing specific Flex-Bay radiator mounting brackets. 5. Cable Management & Final Maintenance
Because aluminum threads can strip if over-tightened, always use a manual screwdriver rather than a power drill. Take your time, and do not over-torque the machine screws holding the case frame together.
Supports up to two radiators mounted vertically on their sides. Requires CaseLabs lower radiator mounts.