Amada Pega 357 User Manual Jun 2026

Used during morning startup to calibrate the machine axes back to their absolute origin points. 3. Basic Programming (G-Codes and M-Codes)

50" x 72" (up to 50" x 144" with auto-repositioning). Max Material Thickness: 0.25" (6.35 mm) mild steel.

Use polyurethane slug ejectors in the punch; utilize vacuum-assist die systems; demagnetize tools after grinding. Problem 3: Overtravel Alarms (X or Y Axis)

Clamp position check and return to reference point. G70: Punching a bolt hole circle. X, Y Coordinates: Directs the high-speed table positioning. amada pega 357 user manual

1270 mm x 3660 mm (50” x 144”) Turret Speed: 30 RPM Hits Per Minute (1" intervals): Approximately 200–220 HPM

Program end and home return (axes return to the loading position, turret initializes). G70: Grid pattern punch. Essential M-Codes

Before a Pega 357 can be moved into a facility, extensive preparation is required. The pre-installation guide outlines highly specific parameters that cannot be ignored. 1. Foundation Specifications Used during morning startup to calibrate the machine

Typically configured with 44 or 58 stations (including Auto-Index stations)

Drain the water traps from the incoming air regulator filter.

For executing programs automatically from memory or external tape readers. Max Material Thickness: 0

Drain accumulated moisture from the pneumatic water separator. X/Y Ball Screws & Linear Guides

Used for manually moving the X and Y axes or rotating the turret using the jog dial or directional buttons. Essential Panel Buttons Cycle Start: Initiates program execution in Memory mode.