Select the (represented by a yellow dashed line).
Comprehensive Guide to Using Media Converters in Cisco Packet Tracer
Router(config)# interface gigabitethernet 0/1/0 Router(config-if)# ip address 10.0.0.1 255.255.255.252 Router(config-if)# no shutdown Router(config-if)# end
Pinging 192.168.1.20 with 32 bytes of data: Request timed out. Reply from 192.168.1.20: bytes=32 time=1ms TTL=128 Reply from 192.168.1.20: bytes=32 time=1ms TTL=128 Reply from 192.168.1.20: bytes=32 time=1ms TTL=128 Use code with caution. Troubleshooting Common Link Issues media converter in cisco packet tracer link
By inserting a fiber module into a device that already possesses built-in copper ports, the switch or router acts internally as the media converter.
Thus, a "media converter link" in Packet Tracer refers to the
For more information on media converters in Cisco Packet Tracer, check out the following resources: Select the (represented by a yellow dashed line)
Look at the bottom-left corner of the Packet Tracer interface.
interface fastEthernet 0/1 switchport mode trunk switchport trunk allowed vlan 10,20
This scenario simulates connecting a primary office building to a remote warehouse located 2 kilometers away. The local devices use copper, but the long-distance link must use fiber. Step 1: Deploy the Network Devices Open Cisco Packet Tracer. Troubleshooting Common Link Issues By inserting a fiber
enable configure terminal interface fastEthernet 0/1 no shutdown switchport mode access switchport access vlan 10 exit interface fastEthernet 0/2 no shutdown switchport mode access switchport access vlan 10 exit vlan 10 name LINK_VLAN exit
The media converter . Because it operates at Layer 1, it blindly forwards the electrical (copper) and optical (fiber) signals, including the VLAN tags inside the Ethernet frames. This works flawlessly in Packet Tracer.
Using Media Converters to Link Fiber and Copper in Cisco Packet Tracer