Test Point Driver Huawei Install -

Windows 7, 8, 10, or 11 (64-bit systems are highly recommended).

: Windows may block the driver because it is not digitally signed. To fix this, run Command Prompt as administrator and enter bcdedit /set testsigning on , then restart your PC.

If your device shows up as "USB SER" in Device Manager, follow these steps to fix it manually: Open Device Manager : Right-click the Start button and select Device Manager Locate the Device : Look under "Other devices" for Update Driver : Right-click "USB SER" and choose Update driver Choose Manual Path "Browse my computer for drivers"

In Device Manager, look under "Other devices." You should see an entry labeled "USB SER" or "Huawei Phone" with a small yellow triangle containing an exclamation mark (!). This indicates the driver is missing.

While holding the tweezers, connect the phone to the PC via a USB cable. 2. Update via Device Manager test point driver huawei install

The term "install" here applies to the entire operation. Here is a review of the steps typically required:

Installing the Huawei USB COM 1.0 driver is a critical step for advanced device servicing, such as unlocking bootloaders or bypassing FRP locks via the hardware "test point" method. When you short the test point on a Huawei motherboard and connect it to a PC, the system often fails to recognize it, displaying a generic error instead. Installation Guide for Huawei Test Point Driver

The device is stuck on the Huawei or Honor logo and cannot access Fastboot or Recovery modes.

If the driver installs but stays broken: Windows 7, 8, 10, or 11 (64-bit systems

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

If done correctly, the phone will be detected under "Other Devices" or "Ports (COM & LPT)" as USB COM 1.0 Install/Update Driver Manually: Right-click (or unknown device) in Device Manager and select Update driver "Browse my computer for driver software" Navigate to the extracted driver folder and select the If Windows warns about driver compatibility, select "Install this driver software anyway" Confirm Installation: The device should now appear as HUAWEI USB COM 1.0 Ports (COM & LPT) III. Troubleshooting & Tips Driver Signature Error:

, you can use the "Software Testpoint ON" feature to avoid physical disassembly. Installing Huawei HiSuite can sometimes pre-install necessary USB drivers.

Upon reboot, press or F7 to select "Disable driver signature enforcement." If your device shows up as "USB SER"

. Without the correct driver, your repair tools (like UnlockTool or Chimera) cannot communicate with the device. Installing the Huawei USB COM 1.0 driver converts this "USB SER" entry into a functional COM port. Installation Guide for Windows 10 & 11

Power off the phone and remove the battery (if applicable/removable).

Windows is blocking the driver due to a lack of a valid digital signature.