Xtra Safe Kt 82001 Manual
With the door open, turn the main knob counterclockwise to extend the locking bolts.
If the manual is still unavailable, your most direct option is to contact the point of sale. Send the seller a message through the platform you used (such as Amazon, eBay, or a specialty store) with your order number and a request for the manual. If possible, contact the manufacturer directly. Their customer service team will likely provide you with a digital file or send you a physical copy.
Push the reset lever (or according to the stamped directional arrow) to lock it into position B . Xtra Safe Kt 82001 Manual
Once configured, operating the safe requires only a few button presses. Unlocking the Safe Digitally Input your pre-programmed 3-to-8 digit code on the keypad. Press the confirmation key ( # / * / B ). The green light will turn on.
| Issue | Probable Cause | Recommended Solution | | :--- | :--- | :--- | | | Dead or low batteries | Insert the Emergency Key to override and open the door. Replace the batteries once inside. | | Keypad beeps, but bolts don't move | Low battery power | The voltage is too low to retract the motor. Replace the batteries. | | Error beep when entering code | Wrong code entered | Re-enter the code carefully. After several failed attempts, the safe may enter a lockout period (e.g., 15 minutes). | | Electronic Key fails | Key not making contact | Remove the key, check for dirt, and re-insert it. If it fails, contact a locksmith. | | Safe is beeping continuously | Low battery warning | Replace the batteries immediately to avoid a lockout. | With the door open, turn the main knob
If the door is left open for more than 10–15 seconds, the bank will often beep repeatedly until closed. ⚠️ Troubleshooting Door Won't Open:
Mastering the Xtra Safe KT 82001: Your Guide to Setup, Programming, and Safety Compliance If possible, contact the manufacturer directly
: Insert the emergency key into the revealed keyhole. Unlock : Turn the key counter-clockwise.
If you forget your code or the batteries die, use the override key to open the safe. Remove the plastic key cover. Use the master override key to open the door. Note: Do not store the override key inside the safe.
When you first receive your lockbox, it will be set to a default factory combination. Step 1: Locate the Dials