+---------------------------+ +---------------------------+ | MASTER CABINET | | SLAVE CABINET | | | | | | [Main CPU Board] | | [Slave Drive Board] | | | | | | | | +---[Sync Harness]----+==============>+-----+ | | | (In Conduit) | | +---------------------------+ +---------------------------+ Access Control Integration
| Error Code / Symptom | Probable Cause (from manual) | Solution | | :--- | :--- | :--- | | | Motor thermal overload tripped or power supply fuse blown. | Wait 10 minutes for reset or replace 5A fuse on the power board. | | Flaps close on user (hitting shin) | IR beam "B3" misaligned or dirty. Lane too wide (over 1000mm). | Clean the IR lens with microfiber cloth. Re-run Auto-Tune calibration. | | Continuous alarm sound | Floor vibration causing sensor bounce. | Install rubber vibration dampening pads under the pedestal (not included, but recommended in appendix C of manual). | | Unit doesn't respond to card reader | Wiring polarity reversed on J5-J8 (Tip vs. Ring). | Swap wires on the "Card In" and "Card GND" terminals. | | Flaps open slowly | Hydraulic damper failure or low temperature (<0°C). | Refer to manual for damper replacement (Part # GSF-DMP-01). Add lane heater kit. |
Once alignment is verified, the fixing holes are marked, the units are moved, and holes are drilled. The units are then re-positioned and securely anchored to the floor. gunnebo speedstile fl installation manual
The Gunnebo SpeedStile FL is a high-speed, bi-directional pedestrian gate designed for high-traffic areas. This manual provides step-by-step instructions for the installation of the SpeedStile FL. It is essential to follow these instructions carefully to ensure a safe and successful installation.
This section transforms the installer’s role from that of a mechanical fitter to a system integrator. The manual guides the user through the Input/Output (I/O) connections, specifying voltage requirements and relay logic. It addresses the critical fail-safe requirements, such as the "Break-out" mode, where glass barriers must drop or open during a fire alarm to ensure unimpeded egress. The technical precision required here is paramount; a misinterpretation of the wiring schematic could lead to life-safety code violations. Furthermore, the manual touches upon the Dip-switch settings or software configuration for lane direction and sensor sensitivity. This demonstrates that the installation is not complete until the "brain" of the turnstile is calibrated to the specific behavioral needs of the site, such as adjusting the sensitivity for tailgating detection versus throughput speed. Lane too wide (over 1000mm)
For detailed, step-by-step illustrations, it is recommended to download the full Gunnebo SpeedStile FL Installation Manual PDF or the SpeedStile FLs BA Series Product Data Sheet .
across the entire footprint of the speed gate array. Uneven floors cause cabinet misalignment, which leads to glass wing collisions or premature drive-mechanism wear. | | Continuous alarm sound | Floor vibration
Remove all tools, packing materials, and personnel from the lane walkway. Turn on the internal circuit breaker.
The SpeedStile FL is designed to be robust, but when issues occur, the LED indicators and buzzer provide essential diagnostic information.
Critical: Ensure the units are perfectly parallel to each other. Misalignment will cause operation failures. 3.2. Anchoring the Units