x
Run the dedicated calibration program or set up a manual program with a heating rate of 10°C/min up to 960°C with no hold time.
Ensure the furnace head closes properly and the seal is clean, as contaminants can cause temperature shifts. 5. Troubleshooting and Error Codes
As an entry-level model in the Programat line, the P100 is renowned for its robustness and simplicity. According to the manual, it is intended for the processing of:
A critical section of the manual is dedicated to vacuum control. Firing ceramics under a vacuum is essential for transparency; it removes air bubbles from the porcelain slurry before it vitrifies. The P100’s ability to precisely time the "vacuum on" and "vacuum off" stages ensures that the resulting crown or bridge has the optical depth of a natural tooth. The manual provides the specific parameters needed to balance air pressure with heat-up rates, a delicate dance of physics that determines the final aesthetic. Maintenance as Longevity
Use a silver test set (silver rod) and place it in the furnace, running a specific calibration program (often Program P99 or similar). ivoclar programat p100 manual english
The Ivoclar Programat P100 Go to product viewer dialog for this item.
If the wire melts early or late, use the temperature offset utility in the system menu to adjust the furnace calibration up or down. General Maintenance Checklist
Select your desired program slot using the program up/down keys (e.g., Program 15 ).
The time (in minutes) it takes for the furnace head to close completely. This manages preheating. Run the dedicated calibration program or set up
Utilizes a numeric keypad for easy data entry and a clear display for setpoint and actual values.
The Programat P100 is a product of decades of engineering evolution. Unlike modern furnaces that rely heavily on touch-screen interfaces, the P100 represents a robust design focused on . Its legacy endures because of its ability to deliver consistent firing results for various indications, including ceramics and pressing techniques.
The manual is due to copyright and file-size constraints. However, you can access the official PDF via these verified methods:
Includes adjustable closing times for the furnace head and a slow cooling function to prevent thermal shock to ceramic restorations. Troubleshooting and Error Codes As an entry-level model
Without this section, your furnace could be firing 30°C too hot, ruining lithium disilicate restorations.
The Programat P100 is specifically designed for firing dental ceramic materials. Using the furnace for other purposes (e.g., curing non-dental materials) can damage the equipment and void the warranty.
Labeled keys to select stored firing sequences.
Understanding the physical and technical parameters of the Programat P100 ensures safe installation and optimal performance.
x