Canon Ir1024 Default Admin Password Jun 2026

The system administrator's password should now be cleared.

Access the (usually by pressing the Additional Functions key, then 2 & 8 simultaneously, then Additional Functions again, or using the *(Tone) > 2+8 > *(Tone) sequence depending on the specific sub-model). Navigate to COPIER > FUNCTION > CLEAR > P-KWD . Select OK . Turn the machine off and back on. 2. Perform a Network Settings Reset

Store the admin password in a password manager accessible to current staff. Print a physical label and place it inside the front cover of the device (not on the outside).

Log in to the with the default credentials ( Administrator / 7654321 ).

To set a new password, select the [Set/Change Password] check box, then enter your new password in both the [Password] and [Confirm] fields. Canon Ir1024 Default Admin Password

Yes, the iR1024, iR1024A, iR1024iF, and iR1025 all share the same default admin password set.

When accessing the device via the physical control panel, you typically enter the ID and the password as the same numeric string.

If the defaults were changed and you are locked out, you can often reset them via : Press Additional Functions (or Settings/Registration).

Yes. Performing an Initialize All Data/Settings operation resets all device settings to factory defaults, including reverting the administrator password back to the original 7654321 . The system administrator's password should now be cleared

There are two primary methods to access the administrative functions of the Canon iR1024: through the Remote UI (web interface) and directly on the device's control panel.

For the majority of Canon imageRUNNER devices, including the , the factory default settings are: System Manager ID System Manager PIN Canon Knowledge Base

Log into the or the Operation Panel using the default credentials. Navigate to System Settings > System Manager Information . Select Edit next to the System Manager ID and PIN. Enter a new unique numeric combination. Save your settings and restart the machine to apply.

If the above method does not work or if password initialization has been prohibited, you can use the device's service mode to clear the system administrator's password: Select OK

Canon released several firmware updates for the IR1024. Early versions (v1.0–v1.5) used 1234567 ; later versions (v2.0+) switched to 7654321 . If you have a very old unit, try the ascending sequence.

If the standard seven-digit code does not grant access, the device may be using an alternative factory default configuration based on its specific firmware version: 2400 / PIN: 2400 ID: 1234567 / PIN: 1234567 ID: Leave Blank / PIN: 7654321 How to Log In as an Administrator

Access Settings/Registration on the physical machine. What to Do If the Password Doesn't Work

No. The Remote UI requires authentication before granting access to any management functions. General users can log in with limited privileges, but administrative access requires administrator credentials.