We use cookies to enhance your experience, analyze site traffic, and personalize content. By clicking “Accept All”, you agree to our use of cookies.

Cookie Preferences

Manage your cookie settings. You can enable or disable different types of cookies below. For more details, see our Privacy Policy.

Usb Device Id Vid Ffff Pid 1201 -

“If that is a fake USB drive with artificially inflated capacity... its quality is also unknown, so you might be better buying a legitimate one from a reputable store.” Reddit · r/techsupport · 3 years ago Recommendation: Proceed with Caution

Set the to "Standard Scan" or "Factory Scan" depending on the tool version.

Run the tool and look for and the Flash ID code . 2. Download the Correct MPTool

If the drive appears in Disk Management, you may be offered the option to format it. However, if the controller is already reporting VID FFFF PID 1201 , any format attempt will likely fail or will only mask the issue temporarily. The proper fix is to reflash the controller using a mass production tool. usb device id vid ffff pid 1201

Once the software indicator turns green and displays a "Success" message, unplug the device and insert it back into your PC. Open Windows Disk Management. You may discover that your original "64GB" drive has now safely re-stabilized as a fully functional 16GB or 32GB drive. The tool has permanently locked out corrupted or fake memory sectors to make the device safe to use again.

File System: The drive will show as RAW, or it will not be detected by file explorer at all. Why Did This Happen?

: A sudden power loss, improper ejection, or degraded memory cells caused the controller chip to panic. To prevent physical burnout, it boots into a generic ROM safe mode. “If that is a fake USB drive with

Once you know the controller model, search for the corresponding “MP tool” (mass production tool) from sources such as:

If the device shows VID FFFF PID 1201 but the computer still recognizes it as a drive (even if size is wrong), you might try software-based data recovery tools.

Click on the or Bin Config button. If prompted for a password, try leaving it blank or entering 123456 or 888888 . The proper fix is to reflash the controller

Attempting to update the drive’s firmware with an incorrect tool or disconnecting the drive during an update will almost certainly corrupt the controller’s flash memory, leaving it with the default identifier.

Set the scan level mode to or Low-Level Format . This forces the software to meticulously test the integrity of every individual physical sector on the flash drive.

The VID FFFF is a reserved value in the USB specification, typically indicating that the device is using a default, un-programmed, or "blank" configuration. This strongly suggests the device is a development board, a prototype, or a consumer device running incomplete firmware. It is rarely associated with legitimate, retail-ready commercial hardware from a major vendor.

Every USB device has a small chip (microcontroller) that stores firmware—the brain of the device. If the firmware becomes corrupt due to a sudden power loss, improper ejection, or a voltage spike, the device reverts to a "bootloader" or "panic" mode. In this mode, it reports VID_FFFF because it cannot load its real configuration.