Lectra Alys 30 Plotter Manual - Exclusive |verified|
Feed the paper under the rear dancer bar, up through the main platen channel, and secure it under the front pinch rollers.
Features status LEDs (Power, Ready, Error, Ink Low) and manual feed buttons. 2. Installation and Initial Setup
Run three consecutive printhead cleaning cycles. Inspect the ink supply line for visible air pockets. Uneven pinch roller tension or misaligned paper roll. lectra alys 30 plotter manual exclusive
The Alys 30 features an integrated control panel that allows you to manage basic functions without needing the computer software. The specific functions of each button and indicator are detailed in the manual's control keyboard section.
| Symptom | Common Misdiagnosis | Actual Fix (From Manual) | | :--- | :--- | :--- | | Plot shifts left after 50cm | Belt slipping | Adjust tensioner screw (Torque 4.5 Nm) | | Paper jams during vacuum | Sensor dust | Clean optical eye with lens cloth, then re-run "Media Length Calibration" (Page 78) | | Serial connection fails | Wrong cable | Use null-modem cable with pins 2-3 crossed, 4-6 looped | | Carriage noise on return stroke | Worn bushing | Replace linear bearing (Part # LA30-LIN-02) – requires hydraulic press | Feed the paper under the rear dancer bar,
The documentation for the Lectra Alys 30 is structured to support both daily operations and technical upkeep:
Network connection failure or software communication error. The Alys 30 features an integrated control panel
The Alys 30 often uses a continuous ink system. Regularly monitor ink levels to prevent air from entering the print heads.
Disclaimer: This guide is intended for informational purposes. Always consult the official Lectra documentation for repairs.
The Lectra Alys 30 relies on precise communication parameters to parse vector marker data. Connecting via JustPrint / Modaris
: The paper must feed over the top of the roll. Feed it into the diagonally angled metal slot until the plotter detects it and auto-pulls it; avoid lifting the manual levers to force it unless the auto-load fails.
